1. Home/
  2. AC and Heating Equipment/
  3. Split System-Ducted/
  4. HVAC Systems/
  5. Arcoaire AC Single Phase Split System Deluxe Single Stg 1.5 Ton 24k BTU AHU 15.5 SEER2
  View Compare ( 0 )
Catalog pricing shown. Please Sign In to see your pricing.

Arcoaire AC Single Phase Split System Deluxe Single Stg 1.5 Ton 24k BTU AHU 15.5 SEER2

Arcoaire AC Single Phase Split System Deluxe Single Stg 1.5 Ton 24k BTU AHU 15.5 SEER2
View Inventory
Kit Includes PVC Ptrap Kit, 50' Line Set 1/2" Insul, PVC Adapters/Fittings, Whip 6' 1/2" 10GA, Furnace Leveler, No Vent Caps, 2" Plastic Pad, 2H/2C Thermostat, Disconnect
Add to Cart
Regional Add to Job List

This retail set contains

Add to Cart
Regional Add to Job List
Vendor Name:
Arcoaire
URI Part Number:
Arcoaire AC Single Phase Split System Deluxe Single Stg 1.5 Ton 24k BTU AHU 15.5 SEER2
Shipping Weight (Lbs.):
200
Energy Star:
Energy Star 6.1 Compliant: 15.2 SEER2, 12.0 EER2
Includes:
H4A6S18AKAWA, FMA4X2400AL, ACBKIT2
Nominal Capacity (BTUH):
18000
Cooling Efficiency (EER2):
13
Cooling Efficiency (SEER2):
15.5
Heating Efficiency HSPF2:
A/C is Energy Star 6.1 compliant
System Indoor Type:
AHU
System Outdoor Type:
Single Stage
System Coil Configuration:
Front Return
System AHU Type:
Specialty AHU (Uncased, Apartment)
System Nominal Tons:
1.5
AHRI System Number:
207908881
A/C, Single Phase, Split AHU Single Stage, Front Return H4A6S/FMA4

Air Conditioner Condenser
  • 80% AFUE
  • Flame roll-out sensors standard
  • Category I venting
  • Blocked vent switch
  • Louvered door
  • 24 VAC and 115 VAC humidifier terminal
  • Electronic air cleaner terminal
  • Select sizes approved for twinning, refer to accessory kit listing
  • N80ESL - Low NOx units are designed for California installations and can be installed in air quality management districts with a 40ng/J NOx emissions limit
  • Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193
  • Adjustable heating blower OFF delay
  • Factory set blower ON delay
  • RPJ aluminized steel heat exchanger
  • High temperature limit control designed to prevent overheating
  • Direct ignition with Silicon Nitride igniter
  • One piece prepainted steel cabinet
  • In-shot burners
  • 33 1/3” (847mm) high, for ease of installation
  • Quarter turn knobs for easy door removal and secure attachment
  • Factory shipped for natural gas, convertible to propane with accessory kit
  • Four position - upflow/downflow/horizontal (left/right) installation
  • Three position inducer elbow capability
  • Through the casing flue pipe for counterflow applications
  • Common venting with other Category I appliances
  • Masonry chimney adapter available
  • Self diagnostics
  • Slide out blower assembly

Front Return Fan Coils

  • Factory installed TXV (4X) - Piston (4P)
  • EC motor (4X) - PSC Motor (4P)
  • Motor suspended on rubber grommets for quieter operation
  • Standard return air grille panel and is convertible to bottom return
  • Replaceable air filter factory supplied with all models
  • Fully insulated for conditioned space (not to be installed in unconditioned spaces)
  • Upflow application only
  • 208/230-1-60 supply voltage
  • Fresh air intake holes (capped from factory)
  • Units fits between standard stud spacing
  • All service access is located in the front
  • Primary and secondary drain connections exit from the bottom
  • No return-air ductwork required in specific applications